In the page of cut management it is possible to apply some optimizations for the machine SX to improve the combination of spindles in cutting phase.

Mode 1

This mode allows to unite two different cuts that are located on the same straight line making them become a single cut.

Mode 2

Try to make all cuts of the same length (maximum).

Mode 3

Normally, after using the handling system it is impossible to move manually the execution of a cut before the move.
With this optimization mode, the software places before the movement the cuts that the machine can execute.

Mode 4

Cuts of similar length become cuts with the same length.

Mode 5

Extend all cuts beyond the slab edge and makes them of similar length, as in mode 2.