Troubleshooting

This document describes troubleshooting procedures for identifying and resolving the most common problems with Donatoni machines and the installed software.

The objective is to reduce machine downtime and guide the operator through the initial diagnosis, indicating when technical support is required.

• TROUBLESHOOTING ARTICLES
  • PE0000 GENERAL EMERGENCY
  • PE0003 MAINS POWER FAILURE
  • PE0005 CONTROL ENABLE MISSING
  • PE0006 WORKTABLE PUMP THERMAL PROTECTION ACTIVE
  • PE0007 SAW BLADE THERMAL PROTECTION ACTIVE
  • PE0008 COLLISION LIMIT SWITCH ACTIVE
  • PE0009 COLLISION POSITION REQUEST
  • PE0010 X-AXIS OVERCURRENT
  • PE0011 Y-AXIS OVERCURRENT
  • PE0012 Z-AXIS OVERCURRENT
  • PE0013 A-AXIS OVERCURRENT
  • PE0014 C-AXIS OVERCURRENT
  • PE0015 SPINDLE OVERCURRENT
  • PE0016 WATER MISSING
  • PE0018 ZERO FEED SET 0
  • PE0019 DRIVE ERROR
  • PE0021 TILTING TABLE NOT IN POSITION
  • PE0023 MUTING ACTIVE
  • PE0027 INTERNAL WATER MISSING
  • PE0028 A AXIS NOT IN CORRECT POSITION
  • PE0029 LUBRICATION SYSTEM FAULT
  • PE0031 ELECTRICAL CABINET OVERTEMPERATURE
  • PE0041 CH 0 PROGRAM WITHOUT M2-M30
  • PE0065 VACUUM PUMP THERMAL PROTECTION ACTIVE
  • PE0066 AIR MISSING
  • PE0067 VACUUM NOT GENERATED
  • PE0069 SUCTION CUPS NOT IN PARKING POSITION
  • PE0070 SUCTION CUPS ALREADY IN CONTACT (ERROR)
  • PE0095 INVERTER ALARM
  • PM0011 PROBE PISTON OUT OF POSITION
• SAFETY INSTRUCTIONS